Rear

Brake Disc

Service Repair No - 70.12.33






Removal
1. Remove rear wheel bearing and hub assembly.
2. Remove disc bolts.
3. Remove disc from rear hub.

Installation
1. Install disc to rear hub.
2. Install disc bolts.T ighten to 73 Nm (54 ft. lbs.).
3. Check total disc runout with a dial indicator, this must not exceed 0.15 mm (0.006 inch). If necessary, reposition disc.
4. Install Rear wheel bearing and hub assembly.

Disc Reclaimation
^ The brake disc MUST BErenewed if the minimum running thickness stamped on the disc is recorded. Check the disc thickness. This dimension may be machined to a minimum thickness of 12 mm. Machine equal amounts off of each face.