Preliminary Checks

PRELIMINARY CHECKS
Inspect battery cables and connections to ensure they are clean and tight. Check battery state of charge if in doubt as to its condition.

Inspect all L.T. connections to ensure that they are clean and tight. Check the H.T. leads are correctly positioned and not shorting to ground against any engine components. The wiring harness and individual cables should be firmly fastened to prevent chaffing.

PICK-UP AIR GAP
Check that the air gap between pick-up limb and reluctor teeth is 0.20 - 0.35 mm, using a non-ferrous gauge.

NOTE: The gap is set initially at the factory and will only require adjusting if tampered with or when the pick-up module is replaced.