Cruise Control Servo: Adjustments

NOTE: Setting procedure is carried out at minimum throttle condition only.

1. Ensure ignition is switched OFF'.

Actuator Link:

2. Check clearance between inside edge of actuator link and recessed diameter of throttle lever. Clearance should be 0.2 to 2.0 mm.

Link - adjust





3. Remove link from actuator.
4. Rotate socket joint adjuster as necessary.
5. Refit link to actuator and recheck clearance between link and lever.
6. With throttle fully open, check a gap of at least 3 mm exists between side of link ('A' in illustration) and side of small spring ("B" in illustration). Realign link by bending to achieve correct gap. Recheck clearance at closed throttle/open throttle. Check link slides smoothly in groove of throttle lever.