Neutral Safety Switch: Service and Repair
Inhibitor switchRemove
1. Release inhibitor switch harness multiplug from clip on fluid pan and disconnect multiplug.
2. Set selector lever to 'N' position.
3. Remove 2 bolts securing inhibitor switch to gearbox and remove inhibitor switch.
Refit
1. Clean inhibitor switch and mating face on gearbox.
2. Align the internal lugs with the mark on the inhibitor switch.
3. Position inhibitor switch, aligning the 2 lugs with the machined grooves in the selector lever shaft.
4. Fit bolts securing inhibitor switch but do not tighten at this stage.
5. Connect inhibitor switch multiplug and secure to mounting bracket with clip.
6. Adjust inhibitor switch.