Rear Fender Liner: Service and Repair

76.10.49 Liner - Rear Wheel Arch - Single

Remove

1. Raise rear of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

2. Remove road wheel.







3. Remove 2 scrivets securing wheel arch liner to sill and bumper.
4. Remove 3 plastic nuts securing inner wheel arch liner.
5. Remove 4 hexagonal headed screws securing wheel arch liner.
6. Release and remove wheel arch liner.

Refit

1. Position wheel arch liner to inner wing.
2. Fit and secure plastic nuts to studs.
3. Fit and tighten screws securing wheel arch liner to wing and bumper.
4. Fit and secure scrivets.
5. Fit road wheel and tighten nuts to 140 Nm (103 lbf.ft).
6. Remove stands and lower vehicle.