Rear Output Shaft Bearing

Rear Output Shaft Bearing

Service repair no - 41.20.19/01

Remove
1. Remove rear output shaft.







2. Remove dust shroud from transfer box rear casing.
3. Using a flat bladed screwdriver free of rough edges, ease oil seal from rear casing.

CAUTION: Do not mark sealing surface on rear casing.

4. Remove rear output shaft oil seal.
5. Remove circlip retaining rear output shaft bearing to rear casing.
6. Press out rear output shaft bearing from rear casing.

Refit
1. Clean bearing and rear casing mating surfaces.
2. Press bearing into rear casing.
3. Fit circlip retaining bearing in rear casing.
4. Clean sealing area of rear casing and running surface of drive flange. Ensure all traces of rubber are removed.

CAUTION: Do not use a metal scraper as this may damage sealing surfaces.

5. Lubricate sealing surfaces of seal with clean gearbox oil.







6. Using LRT-41-013, fit oil seal to transfer gearbox rear casing.
7. Fit dust shroud to transfer box rear casing.
8. Fit rear output shaft.