Gear Sensor/Switch: Service and Repair

High/Low Range Sensor

Service Repair No - 41.30.07

Removal

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

1. Raise and support the vehicle.
2. Remove the transmission support insulator nut, bolt and damper.
^ Support the transmission.





CAUTION: To avoid damage to the joints or gaiters, do not allow the transmission to hang on the driveshafts.

3. Remove the high/low range sensor.
^ Lower the transmission.
^ Disconnect the electrical connector.
^ Remove the 2 Torx bolts.





Installation
1. Install the high/low range sensor.
^ Clean the components.
^ Tighten the Torx bolts to 6 Nm (4 ft. lbs.).
^ Connect the electrical connector.

2. Install the transmission support insulator nut, bolt and damper.
^ Tighten the bolt to 115 Nm (85 ft. lbs.).

3. Using T4, calibrate a new high/low range sensor.