Front Door Window Glass: Adjustments

Door glass setting procedure

NOTE:
Make sure that this procedure is carried out if any concern is with noise or if directed by a pinpoint test.
1 Remove the door trim panel as necessary. For additional information, refer to Front Door Trim Panel Service and Repair
For additional information, refer to Rear Door Trim Panel Service and Repair
2 Release but do not remove the door window glass retaining clip(s) bolt(s).
3 Operate the window switch up and down seven times to make sure that the door window glass is correctly installed to the door window seal.





4
NOTE:
Make sure that the retaining clips are installed as illustrated.
Install the door window glass to the retaining clips, first to the front retaining clip and then to the rear.
5 Push the door window glass to the rear of the door to make sure correct installation in to the door window glass seal.
6
NOTE:
Tighten the rear retaining clip bolt first then the front bolt.
Tighten the door window glass retaining clip bolts to 10 Nm.
7
NOTE:
Make sure that there is a minimum of 5mm engagement of the door window glass to the rear door channel when the door window glass is fully closed.
Check the system for normal operation.