Confirmation Driving Pattern

CONFIRMATION DRIVING PATTERN

Confirmation Driving Pattern:

a. Connect the hand-held tester to the DLC3.
b. Switch the hand-held tester from the "normal mode" to "check mode".
c. Start the engine and let the engine idle for 100 seconds or more.
d. Drive the vehicle at 40 km/h (25 mph) or more for 20 seconds or more.
e. Let the engine idle for 20 seconds or more.
f. Let the engine idle for 30 seconds.

HINT: If a malfunction exists, the MIL will light up during step (f).

NOTE: If the conditions in this test are not strictly followed, detection of the malfunction will be impossible.
If you do not have the hand-held tester, turn the ignition switch OFF after performing steps (c) to (f), then perform steps (c) to (f) again.