Component Tests and General Diagnostics

PROCEDURE

1. Remove the No. 3 timing belt covers.
2. Disconnect the high-tension cord (from the ignition coil) from the distributor caps.
3. Hold the end approximately 12.5 mm (0.50 in) from the body ground.
4. See if spark occurs while the engine is being cranked.

CAUTION: To prevent gasoline from being injected from injectors during this test, crank the engine for no more than 1 - 2 seconds at time.

5. If the spark does not occur, perform the tests as illustrated.





6. Reconnect the No. 3 timing belt covers and the high-tension cords.