Component Inspection

COMPONENTS FOR REMOVAL AND INSTALLATION

KNOCK SENSORS INSPECTION
1. REMOVE STARTER.

2. REMOVE PS PUMP REAR STAY.




3. REMOVE KNOCK SENSORS.
- Disconnect the knock sensor connector.
- Using SST 09816-30010, remove the knock sensor.




4. INSPECT KNOCK SENSORS.
- Using an ohmmeter, check that there is no continuity between the terminal and body.
- If there is continuity, replace the sensor.




5. REINSTALL KNOCK SENSORS.
- Using SST 09816-30010, install the knock sensor.

Torque: 44 N.m (450 kgf.cm. 33 ft.lbf)

- Connect the knock sensor connector.

6. REINSTALL PS PUMP REAR STAY.

Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)

7. REINSTALL STARTER.