Crankshaft Position Sensor: Service and Repair

COMPONENTS FOR REMOVAL AND INSTALLATION

REMOVAL:





1. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY.

CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

2. REMOVE ENGINE UNDER COVER.





3. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.
4. REMOVE CRANKSHAFT POSITION SENSOR.
- Remove the bolt and crankshaft position sensor.

INSTALLATION:





1. INSTALL CRANKSHAFT POSITION SENSOR.
- Install the crankshaft position sensor with the bolt.

Torque: 6.4 Nm (56 in lb)

2. CONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.
3. INSTALL ENGINE UNDER COVER.
4. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY.