Receiver Dryer: Testing and Inspection

ON-VEHICLE INSPECTION

INSPECT FITTINGS FOR LEAKAGE
Using a gas leak detector, check for leakage.
It there is leakage, check the tightening torque at the joints.

REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

INSTALLATION HINT: Evacuate air from refrigeration system.

Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount:
800 ± 50 g (28.22 ± 1.76 oz.)

2. REMOVE RADIATOR UPPER SUPPORT SEAL




3. DISCONNECT 2 LIQUID TUBES FROM RECEIVER
Remove the 2 bolts and both tubes.
Torque: 5.4 Nm (55 kg.cm, 48 in.lb)

REMOVAL NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.

INSTALLATION HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.

4. REMOVE RECEIVER
a. Remove the holder bolt and pull out receiver downward.

INSTALLATION HINT: If receiver was replaced, add compressor oil to compressor.

Add 20 cc (0.71 fl.oz.) Compressor oil:
ND-OIL 8 or equivalent
b. Remove the 2 bolts and holder.

INSTALLATION
Installation is in the reverse order of removal.