RF Door

LOCATION

INSPECTION

Front Passenger's Door Motor:




a. Disconnect the connector from the power window switch.
b. Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 3 on the wire harness side connector, and raise the window to full closed position.
c. Continue to apply voltage, check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.




d. Reverse the polarity, check that the window begins to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.
Rear Left Side Door:
See step of Front Passenger Door Motor.
Rear Right Side Door:
See step of Front Passenger Door Motor.