Receiver Dryer: Service and Repair
RECEIVER REMOVAL1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
INSTALLATION HINT: Evacuate air from refrigeration system.
Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount:
700 ± 50 g (29.69 ±.76 oz.)
2. DISCONNECT 2 LIQUID TUBES
Remove the 2 bolts and both tubes.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
REMOVAL NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.
INSTALLATION HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.
3. REMOVE RECEIVER
Remove the holder bolt and pull out the receiver.
INSTALLATION HINT: If receiver was replaced, add compressor oil to compressor.
Add 10 cc (0.34 fl.oz.)
Compressor oil:
ND-OIL 8 or equivalent
RECEIVER INSTALLATION
Installation is in the reverse order of removal.