With Driving Position Memory
w/ Driving position memory1. INSPECT MIRROR MOTOR OPERATION
(a) Connect the positive (+) lead from the battery to terminal 12 and negative (-) lead to terminal 13, then check that the mirror turns to left side.
(b) Reverse the polarity and check that the mirror turns to right side.
(c) Connect the positive (+) lead from the battery to terminal 3 and negative (-) lead to terminal 13, then check that the mirror turns upward.
(d) Reverse the polarity and check that the mirror turns downward.
2. INSPECT MIRROR POSITION SENSORS
HINT: Strip off the vinyl tape of the connector and remove terminals 3, 8, 10, 11 and 13 from the connector housing.
(a) Connect a series of three 1.5 V dry cell batteries.
(b) Connect the positive (+) lead from the dry cell batteries to terminal 11 and the negative (-) lead to terminal 8.
(c) Connect the positive (+) lead from the voltmeter to terminal 10 and the negative (-) lead to terminal 8.
(d) Apply battery positive voltage to terminals 3 and 13, then check that the voltage gradually changes according to the table below while the mirror moves between the uppermost position and lowermost
position.
If voltage value is not as specified, replace the motor assembly.
(e) Disconnect the 2 leads of the battery and voltmeter.
(f) Connect the positive (+) lead from the voltmeter to terminal 9 and negative (-) lead to terminal 8.
(g) Apply battery positive voltage to terminals 12 and 13, then inspect that the voltage gradually changes according to the table below while the mirror moves between the left-most position and rightmost position.
If voltage value is not as specified, replace the motor assembly.