Inspecting Alignment

1. Measure the vehicle height

NOTE: Before inspecting the wheel alignment, adjust the vehicle height to the specification.

2. Install the camber - caster - kingpin gauge onto the vehicle or the position vehicle on wheel alignment tester making sure to follow the specific instructions on the equipment manufacturer.
3. Inspect the camber,the measurement should be -0°48'+ 45' (-0.80° + 0.75°). The left right error is 45' (0.75°) or less.

NOTE: Camber is not adjustable, it measurement is not within the specification, inspect the suspension parts for damaged and/or worn-out parts and replace them if necessary.

Measuring Point Reference:

4. Inspect the toe-in, the toe-in (totals) are as follows.
A+B: 0°24' + 12' (0.4° + 0.2°).
C-D: 4 + 2 mm (0.16 + 0.08 inch).

NOTE: If the toe-in is not within the specification, adjust it at the No.2 lower suspension arm.