Removal

NOTE: Do not open the cover or the case of the ECU and various computers unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)






1. REMOVE THESE PARTS:
a. Finish plate
b. End Pad
c. No.1 under cover
d. Hood lock release lever
e. No.1 safety pad
f. No.2 under cover
g. Glove compartment finish plate
h. Glove compartment panel assembly
i. Front ash receptacle
j. Cluster finish panel
k. Console box carpet
I. Accessory socket.
m. Accessory case
n. Lower rear console box
o. Rear console armrest
p. Console box register
q. Console box
r. No.3 console box mounting bracket
s. No.1 console box duct






2. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor connectors.

NOTE: Remove the connectors with the sensor assembly installed.

b. Using a torx wrench, remove the 3 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)