Front

INSPECTION





1. MEASURE PAD LINING THICKNESS
Using a ruler, measure the load lining thickness.
Standard thickness: 12.0 mm (0.472 inch)
Minimum thickness: 1.0 mm (0.039 inch)
Replace the pad if the pad's thickness is at the minimum or less, or if the pad has severe, uneven wear.
2. RIGHT WHEEL: INSPECT PAD WEAR INDICATOR





a. Disconnect the pad wear indicator connector from the speed sensor wire harness.





b. Check that continuity exists of pad wear indicator connector.
If no continuity exists, replace the pad wear indicator.
c. Connect the connector to the speed sensor wire harness until the clicking sound can be heard.