Reference Charts

HINT: If using a standard bearing, replace it with one having the same number. If the number of the bearing cannot be determined, select the correct bearing by adding together the numbers imprinted on the cylinder block and crankshaft, then refer to the table below for the appropriate bearing number. There are 5 sizes of the standard bearings. For No.1 and No.5 position bearings, use bearings marked "3","4","5","6" and"7". For others position bearings, use bearings marked "l ", "2", "3", "4" and "5".





No.1, No.5


EXAMPLE:
Cylinder block "08" + Crankshaft "06" = Total number 14 (Use bearing "4"(Upper), "5" (Lower))





Others


EXAMPLE:
Cylinder block "08" + Crankshaft "06" = Total number 14 (Use bearing "2" (Upper), "3" (Lower))





Reference Cylinder Block Main Journal Bore Diameter (A)






Crankshaft Main Journal Diameter (B)


Standard Bearing Center Wall Thickness:






No.1 and No.5






Others