Instrument Cluster / Carrier: Testing and Inspection

1. INSPECT COMBINATION METER CIRCUIT







Connector disconnected:
Disconnect connector "A" and "B" from the combination meter and inspect the connectors on the wire harness side as shown in the table.

If circuit is not as specified, wiring diagram and inspect the circuits connected to other parts.

2. INSPECT INSTRUMENT PANEL INTEGRATION ECU CIRCUIT
a. Remove the combination meter cover.







b. Inspect the connectors on the ECU as follows.

If circuit is not as specified, replace the circuit plate.

3. INSPECT COMBINATION METER ECU CIRCUIT
a. Remove the combination meter cover.




b. Inspect the connectors on the instrument panel integration ECU as follows.

If circuit is not as specified, replace bulb or combination meter ECU.