Removal and Installation

REMOVAL




1. REMOVE ENGINE UNDER COVER
2. REMOVE DRIVE BELT
Loosen the belt tension by turning the drive belt tensioner clockwise, and remove the drive belt.

NOTE: At the time of installation, please refer to the following items. Do an on-vehicle inspection.




3. REMOVE GENERATOR
a. Disconnect the generator connector.
b. Remove the cap and nut, and disconnect the generator wire.
c. Disconnect the generator wire clamp from the wire clip on the generator.




d. Remove the bolt and pipe clamp, and disconnect the 2 A/T oil cooler pipes from the generator.
e. Remove the bolt, nut, pipe bracket and generator.
Torque: 40 Nm (400 kg.cm, 30 ft.lb)


REPLACEMENT




1. REPLACE FRONT BEARING
a. Remove the 4 screws, bearing retainer and bearing.




b. Using a socket wrench and press, press out the bearing.




c. Using SST and a press, press in a new bearing.
SST 09950-60010 (09951-00500)
d. Install the bearing retainer with the 4 screws.
Torque: 3.0 Nm (31 kg.cm, 27 in.lb)




2. REPLACE REAR BEARING
a. Using SST, remove the bearing cover (outside) and bearing.
SST 09820-00021

NOTE: Be careful not to damage the fan.

b. Remove the bearing cover (inside).




c. Place the bearing cover (inside) on the rotor.




d. Using SST and a press, press in a new bearing.
SST 09820-00030




e. Using SST push in the bearing cover (outside).
SST 09285-76010

INSTALLATION
Installation is in the reverse order of removal.