Transmission Position Sensor/Switch: Service and Repair

ON-VEHICLE REPAIR
1. REMOVE FRONT EXHAUST PIPE
2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
3. REMOVE PARK/NEUTRAL POSITION SWITCH





a. Remove the nut and disconnect the control shaft [ever.
b. Pry off the nut stopper.





c. Remove the nut and lock washer.





d. Remove the bolt and park/neutral position switch.
4. INSTALL PARK/NEUTRAL POSITION SWITCH
a. Install the park/neutral position switch with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)





b. Install the nut and a new lock washer.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
c. Stake the nut with the lock washer.





d. Connect the control shaft lever with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft. lbs.)
5. INSTALL FRONT EXHAUST PIPE