Brake Fluid Level Sensor/Switch: Testing and Inspection

NOTE: This article contains changes called out by TSB# PG008-05.





INSPECT BRAKE WARNING LIGHT
a. Disconnect the connector from the brake fluid warning switch.
b. Release the parking brake pedal.
c. Connect the terminals on the wire harness side of the level warning switch connector.
d. Start the engine, check that the warning light lights up. If the warning light does not light up, test the bulb or wire harness.




INSPECT BRAKE FLUID LEVEL WARNING SWITCH CONTINUITY
a. Remove the reservoir tank cap and strainer.
b. Disconnect the connector.
c. Check that no continuity exists between the terminals with the switch OFF (float up).
d. Use siphon, etc. to take fluid out of the reservoir tank.
e. Check that continuity exists between the terminals with the switch ON (float down)
f. Pour the fluid back in the reservoir tank.
If operation is not as specified, replace the switch.