Component Inspection

SFI SYSTEM

INSPECTION




1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSY [11101J]
a. Using an ohmmeter, measure the resistance between the terminals.

Resistance: 6.9 - 7.9 Ohms at 20°C (68°F)

b. Connect the positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.




If operation is not as specified, replace the valve.




2. INSPECT E.F.I. CIRCUIT OPENING RELAY ASSY [85910A]
a. Using an ohmmeter, check that there is continuity between terminals 1 and 2.
b. Check that there is no continuity between terminals 3 and 5.




3. INSPECT E.F.I ECU RELAY [85910F]
a. Using an ohmmeter, check that there is continuity between terminals 1 and 2.
b. Check that there is no continuity between terminals 3 and 5.







4. INSPECT FUEL PUMP RELAY ASSY [28380]
a. Inspect the relay continuity.
1. Using an ohmmeter, check that there is continuity between the terminals.




5. INSPECT CAM POSITION SENSOR ASSY [19300C]
a. Using an ohmmeter, measure the resistance between the terminals.

NOTE: Terms "when cold" and "when hot" in this text show the temperature of the part itself to be inspected. Also, the temperature setting range is 20 ± 30°C when cold and 75 ± 25°C when hot.