Component Inspection
INSPECTION1. REMOVE NO.3 TIMING BELT COVER
2. REMOVE OIL CONTROL VALVE
a. Disconnect the oil control valve connector.
b. Remove the bolt, oil control valve and O-ring.
3. INSPECT OIL CONTROL VALVE OPERATION
Connect positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.
If operation is not as specified, replace the valve.
4. REINSTALL OIL CONTROL VALVE
a. Install a new O-ring to the oil control valve.
b. Install the oil control valve with the bolt.
Torque: 8.0 Nm (80 kgf.cm, 71 in.lbf)
c. Connect the oil control valve connector.
5. REINSTALL NO.3 TIMING BELT COVER
Torque: 8.0 Nm (80 kgf.cm, 71 in.lbf)