Speed Sensor, Front
SPEED SENSOR FRONT LHREPLACEMENT
HINT: Replacement of RH side is same as that of LH side.
1. REMOVE FRONT WHEEL
2. REMOVE SPEED SENSOR FRONT LH
a) Disconnect the speed sensor connector.
b) Using a hexagon wrench (5 mm), remove the bolt and front speed sensor from the steering knuckle.
NOTICE:
^ Do not stick a foreign matter on the sensor tip.
^ Do not let the foreign matter into the sensor installation hole.
3. INSTALL SPEED SENSOR FRONT LH
a) Using a hexagon wrench (5 mm), install the front speed sensor with the bolt to the steering knuckle.
Torque: 8.3 Nm (85 kgf-cm, 73 inch lbs.)
NOTICE: Make sure the sensor tip is clean.
b) Connect the speed sensor connector.
4. INSTALL FRONT WHEEL
Torque: 112 Nm (1,142 kgf-cm, 83 ft. lbs.)
5. CHECK VSC SENSOR SIGNAL
Refer to Antilock Brakes / Traction Control Systems; Testing and Inspection.