Airbag Sensor Rear RH
REPLACEMENT1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE QUARTER SCUFF PLATE INNER RH
4. REMOVE FRONT DOOR SCUFF PLATE RH
5. REMOVE QUARTER SCUFF PLATE INNER RH
6. REMOVE REAR DOOR SCUFF PLATE RH
7. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
9. REMOVE LAP BELT OUTER ANCHOR COVER
10. REMOVE CENTER PILLAR GARNISH LOWER RH
11. REMOVE FRONT SEAT OUTER BELT ASSY RH
12. REMOVE AIR BAG SENSOR REAR RH
a. Remove the 2 nuts and side airbag sensor assy RH.
b. Disconnect the connector from the side airbag sensor assy RH.
13. INSTALL AIR BAG SENSOR REAR RH
a. Connect the side airbag sensor assy RH connector.
b. Install the side airbag sensor assy RH with the 2 nuts.
Torque: 17.5 Nm (178 kgf.cm, 13 ft.lbf)
NOTE:
- Installation of the connector is done with the sensor assy installed. Make sure the sensor assy is installed with the specified torque.
- If the sensor assy has been dropped, or there are cracks, dents or other detects in the case, bracket or connector, replace the sensor assy with a new one.
- When installing the sensor assy, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assy to check that there is no looseness.
14. INSPECT AIR BAG SENSOR REAR RH
15. INSTALL FRONT SEAT OUTER BELT ASSY RH
Torque:
Upper bolt: 7.5 Nm (76 kgf.cm, 66 in.lbf)
Lower bolt: 42 Nm (430 kgf.cm, 31 ft.lbf)
16. INSPECT SRS WARNING LIGHT
Refer to Air Bag Systems; Testing and Inspection.