Steering Angle Sensor: Service and Repair
STEERING SENSORREPLACEMENT
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE. TERMINAL
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING WHEEL COVER LOWER NO.3
5. REMOVE STEERING WHEEL COVER LOWER NO.2
6. REMOVE HORN BUTTON ASSEMBLY
7. REMOVE STEERING WHEEL ASSEMBLY
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
8. REMOVE STEERING COLUMN COVER
9. REMOVE SPIRAL CABLE SUB-ASSEMBLY
10. REMOVE TURN SIGNAL SWITCH ASSEMBLY
11. REMOVE STEERING SENSOR
a) Remove the steering sensor connector.
b) Remove the 2 claws and remove the steering sensor.
c) Remove the 10 steering sensor terminals from the connector
12. INSTALL STEERING SENSOR
a) Follow the table below to install the 10 steering sensor terminals on the connector
b) Install the steering sensor.
c) Install the steering sensor connector.
13. INSTALL TURN SIGNAL SWITCH ASSEMBLY
14. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
15. INSPECT SPIRAL CABLE SUB-ASSEMBLY
a) If the following condition is identified, replace the spiral cable sub-assembly with new one.
Condition: Scratches or cracks on the connector Cracks, dents or chipping of the spiral cable sub-assembly
16. INSTALL SPIRAL CABLE SUB-ASSEMBLY
17. INSTALL STEERING COLUMN COVER
18. CENTER SPIRAL CABLE
19. INSTALL STEERING WHEEL ASSEMBLY
20. INSPECT HORN BUTTON ASSEMBLY
21. INSTALL HORN BUTTON ASSEMBLY
22. INSTALL STEERING WHEEL COVER LOWER NO.2
23. INSTALL STEERING WHEEL COVER LOWER NO.3
24. INSPECT SRS WARNING LIGHT
Refer to Antilock Brakes / Traction Control Systems; Testing and Inspection.