Outside Mirrors

INSPECTION

1. INSPECT OUTER MIRROR SWITCH ASSY







a. Select "L" or "R" on the left/right adjustment switch.
Measure the switch resistance.
If the result is not as specified, replace the switch assy.




b. Measure the left/right adjustment switch resistance.
If the result is not as specified, replace the switch assy.







c. Measure the retract switch resistance.
If the result is not as specified, replace the switch assy.







d. Measure the clearance sonar switch resistance.
If the result is not as specified, replace the switch assy.







2. INSPECT SEAT MEMORY SWITCH
a. Measure the switch resistance.
If the result is not as specified, replace the switch assy.







3. INSPECT OUTER REAR VIEW MIRROR ASSY LH
a. Disconnect the mirror connector.
b. Apply battery voltage and check operation of the mirror.
If the result is not as specified, replace the mirror assy.







c. Apply battery voltage and check the mirror retract operation.

NOTE:
- Disconnect and reconnect the battery once between each mirror position check.
- The mirror position cannot be changed manually when the battery is connected. If you wish to change the mirror position manually, disconnect the battery first before doing so.

If the result is not as specified, replace the mirror assy.







4. INSPECT OUTER REAR VIEW MIRROR ASSY RH
a. Disconnect the mirror connector.
b. Apply battery voltage and check operation of the mirror.
If the result is not as specified, replace the mirror assy.







c. Apply battery voltage and check the mirror retract operation.

NOTE:
- Disconnect and reconnect the battery once between each mirror position check.
- The mirror position cannot be changed manually when the battery is connected. If you wish to change the mirror position manually, disconnect the battery first before doing so.
If the result is not as specified, replace the mirror assy.







5. INSPECT MIRROR POSITION SENSOR
a. Check the voltage.
1. Apply voltage to the terminals with a battery and a dry cell battery, as shown in the table.
2. Measure the voltage while the mirror moves between the fully turned downward position and fully turned upward position.
If the result is not as specified, replace the mirror assy.




3. Measure the voltage while the mirror moves between the fully turned to the left position and fully turned to the right position.




Standard (right side mirror):
If the result is not as specified, replace the mirror assy.




Standard (left side mirror):
If the result is not as specified, replace the mirror assy.