Instrument Cluster / Carrier: Service and Repair

OVERHAUL

HINT:
1. REMOVE INSTRUMENT PANEL FINISH PLATE
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT
3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY




4. REMOVE COMBINATION METER ASSEMBLY
a. Remove the 4 screws.
b. Loosen the 2 bolts and remove the combination meter assembly.




5. REMOVE SPEEDOMETER GLASS
a. Remove the 2 screws.
b. Disengage the 7 claws and remove the speedmeter glass.

6. REMOVE COMBINATION METER COVER NO.1




7. REMOVE COMBINATION METER COVER NO.2
a. Remove the 3 screws.
b. Disengage the 8 claws and remove the combination meter cover No.2.




8. REMOVE INCLINATION SENSOR ASSEMBLY
a. Remove the 2 screws.
b. Disconnect the connectors and remove the inclination sensor assembly.

9. INSTALL COMBINATION METER ASSEMBLY




a. Pull the check pin backward while pressing the check pin with a flat-head screwdriver as shown in the illustration.
b. Check that the wire harness connector is engaged in the instrument panel safety pad installation position.
c. Install the 4 screws in order as shown in the illustration.
d. Tighten the 2 connector fitting bolts until a clicking sound can be heard.




e. After tightening, check that the check pin protrudes.

10. INCLINATION SENSOR 0° CORRECTION

NOTE:
- When replacing or removing/installing the combination meter assembly and the inclination sensor assembly, be sure to perform 0° correction of the inclination sensor.
- When performing 0° correction, install the combination meter assembly and perform it on level surface.
- Also perform 0° correction when the body level setting is inclined because of vehicle height adjustment.

a. Turn the ignition switch off.
b. While pressing the odo/trip switch, turn the ignition switch on.
c. Within 5 seconds after the ignition switch is turned on, repeat pressing and releasing the odo/trip switch 3 times and keep holding the last press for more than 5 seconds. (Buzzer sounds for a second)

NOTE: If the buzzer does not sound, perform this procedure from the first.

d. Release the odo/trip switch when the buzzer sounds.
e. Press the odo/trip switch again and keep pressing for more than 5 seconds. (Buzzer sounds for a second again)

HINT:
- The buzzer sounds twice, reset operation is completed.
- The buzzer sound at the first time is the same as the sound of the second time.





NOTE: If the buzzer does not sound or keep sounding for more than 1 second, perform the procedure from the first.