Repair Procedure - Install Interior Parts - Steps 31 - 45

31. Install the A/C suction hose sub-assembly by tightening the nut.

Torque: 9.8 N-m (100 kgf-cm, 87 in.-lbf)






32. Install the radiator reserve tank by tightening the 3 bolts.

Torque: 5.0 N-m (kgf-cm, in.-lbf)






33. Install the P/S reserve tank by putting the reserve tank in the bracket from the upper side.






34. Install the skid control sensor bracket and connect the wire harness connector (right engine compartment).
A. Install the bracket in the right tire apron.
B. Connect the two (2) wire harness connector.

35. Raise the vehicle.






36. Install the tube sub-assembly heat exchanger and rear A/C tube by tightening the nut.

Torque: 9.8 N-m (100 kgf-cm, 87 in.-lbf)






37. Install the tube sub-assembly heat exchanger bracket.





38. Install the front fender apron seal clip by engaging the two (2) upper clips on the front fender apron seal.






39. Install the bracket cooler RH and LH by tightening the bolt.

Torque: 47 N-m (479 kgf-cm, 416 in.-lbf)

Bracket Cooler: P/N 88688-6A770

Bolt Hexagon: P/N 90105-12122

NOTE:
- "L" is marked on the bracket cooler LH.
- "R" is marked on the bracket cooler RH.





40. Apply seal packing to center position of the front engine under cover sub-assembly.

Seal Packing: P/N 36867-60080






41. Apply seal packing to the right and left of the front engine under cover sub-assembly.

Seal Packing: P/N 36867-60090






42. Install engine under cover sub-assembly No. 1 by tightening the four (4) bolts.

Torque: 29 N-m (296 kgf-cm, 257 in.-lbf)






43. Install the engine under cover sub-assembly No. 2 by tightening the four (4) bolts.

Torque: 29 N-m (296 kgf-cm, 257 in.-lbf)






44. Install the front bumper cover lower by installing the two (2) bolts and two (2) clips.

45. Lower the vehicle.