Speed Sensor, Front
SPEED SENSOR FRONT LHREPLACEMENT
HINT: Replace the RH side by using the same procedures as those for the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
3. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.
b. Remove the 2 bolts and the clamp from the body and the shock absorber assembly.
c. Remove the bolt and the speed sensor front.
NOTICE: Prevent foreign matter from attaching to the sensor tip.
4. INSTALL SPEED SENSOR FRONT LH
a. Install the speed sensor front with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: Prevent foreign matter from attaching to the sensor tip.
b. Install the speed sensor front with the 2 bolts and the clamp.
Torque:
Bolt A: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
Bolt B: 29 Nm (296 kgf-cm, 21 ft. lbs.)
NOTICE: Do not twist the sensor wire when installing the sensor.
c. Connect the speed sensor connector.
5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
6. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
7. CHECK ABS SPEED SENSOR SIGNAL