Check DLC3

Check the DLC3







The vehicle's ECM uses ISO 9141-2 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 9141-2 format.

HINT: If the display shows "UNABLE TO CONNECT TO VEHICLE" when the hand-held tester is connected to the DLC3 and the ignition switch is ON, there is a problem on either the vehicle side or the tool side.
- If communication is normal when the tool is connected to another vehicle, check the DLC3 in the original vehicle.
- If communication is still not possible when the tool is connected to another vehicle, the problem is probably in the tool itself. Consult with the Service Department listed in the Tool's Instruction Manual.