Height Control Valve Sub-Assembly No.1
HEIGHT CONTROL VALVE SUB-ASSEMBLY NO.1REPLACEMENT
NOTICE:
^ Before replacement, press the height control OFF switch to stop the vehicle height control operation.
^ Be careful that the vehicle body lowers because the air in the pneumatic cylinder is discharged by disconnecting the pneumatic cylinder side air tube of the height control valve.
^ This operation takes out the air from the front shock absorber, therefore never rotate the lower part of the absorber by turning the steering wheel etc
1. REMOVE ENGINE UNDER COVER NO.1
2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
4. REMOVE FRONT BUMPER COVER
5. REMOVE HEIGHT CONTROL VALVE SUB-ASSEMBLY NO.1
a. Disconnect the connector.
b. Disconnect the 3 height control tubes.
HINT: For the removal procedure of the (type 3) tube, refer to Service Precautions; Vehicle Damage Warnings.
c. Remove the 2 nuts and the height control valve sub-assembly No 1.
6. INSTALL HEIGHT CONTROL VALVE SUB-ASSEMBLY NO.1
a. Install the height control valve sub-assembly No.1 with the 2 nuts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
b. Coat 2 new O-rings with MP grease No.2 and install them on each height control tube.
c. Connect the 3 height control tubes onto the height control valve sub-assembly No.1.
HINT: For the removal procedure of the (type 3) tube, refer to Service Precautions; Vehicle Damage Warnings.
d. Connect the connector.
7. INSPECT AIR LEAK
8. INSTALL FRONT BUMPER COVER
9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
11. INSTALL ENGINE UNDER COVER NO.1