Transmission Cooler: Service and Repair
OIL W/HOSE COOLER ASSEMBLYREPLACEMENT
1. REMOVE FRONT BUMPER COVER
2. DRAIN AUTOMATIC TRANSAXLE FLUID
a. Remove the drain plug and gasket, and drain ATF.
b. Install a new gasket and the drain plug.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
3. REMOVE OIL W/HOSE COOLER ASSEMBLY
a. Disconnect the 2 oil cooler hoses.
b. Remove the bolt, nut and oil cooler assembly.
4. INSTALL OIL W/HOSE COOLER ASSEMBLY
a. Install the oil cooler assembly, bolt A and nut B.
HINT: After temporarily tightening the bolt A, fully tighten in order of the nut B. bolt A.
Torque: 7.0 Nm (71 kgf-cm, 62 inch lbs.)
b. Connect the 2 oil cooler hoses.
5. INSTALL FRONT BUMPER COVER
6. ADD AUTOMATIC TRANSAXLE FLUID
7. INSPECT AUTOMATIC TRANSAXLE FLUID