Transfer RH Bearing Retainer Oil Seal
TRANSFER RH BEARING RETAINER OIL SEALREPLACEMENT
HINT: COMPONENTS: Refer to Transfer Case; Diagrams; Exploded Views.
1. DRAIN AUTOMATIC TRANSAXLE FLUID
2. REMOVE TRANSFER CASE NO.1 PLUG
3. REMOVE TRANSFER DRAIN PLUG
a. Remove the transfer drain plug, drain gasket and bleed the drain transfer oil.
4. REMOVE FRONT WHEEL
5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
SST 09520-01010, 09520-24010 (09520-32040)
6. REMOVE TRANSFER RH BEARING RETAINER OIL SEAL
a. Using SST(s), remove the transfer RH bearing retainer oil seal.
SST 09308-00010
NOTICE: Do not damage the oil-seal-fitted surface of the case.
7. INSTALL TRANSFER RH BEARING RETAINER OIL SEAL
a. Using SST(s), install a new transfer RH bearing retainer oil seal to the transfer case at the position shown in the illustration.
SST 09223-46011
NOTICE: Do not install the oil seal obliquely.
b. Apply small amount of MP grease to the oil seal lip.
8. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. ADD AUTOMATIC TRANSAXLE FLUID
11. INSPECT AUTOMATIC TRANSAXLE FLUID
12. INSTALL TRANSFER DRAIN PLUG
a. Install the transfer drain plug with a new drain gasket.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
13. INSTALL TRANSFER CASE NO.1 PLUG
a. Add oil up to 0 to 5 mm (0 to 0.20 inch) below the lower side of the plug hole.
Oil amount: 0.9 L (0.95 US qts, 0.71 Imp.qts)
HINT: When adding oil, pour it slowly.
b. Install the transfer case No. 1 plug with a new gasket No.1.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
15. CHECK ABS SPEED SENSOR SIGNAL
a. Check the speed sensor signal.