Rear Suspension Arm Assembly No.1 LH

2WD Models:

4WD Models:

REAR SUSPENSION ARM ASSEMBLY NO.1 LH
REPLACEMENT

NOTICE:
^ Press the height control switch to stop the vehicle height control operation before jacking up or lifting up the vehicle with air suspension.
^ Press the height control switch to operate the vehicle height control after jacking down or lifting down the vehicle with air suspension.
^ Support the rear axle carrier with a jack.

1. REMOVE REAR WHEEL
2. REMOVE STABILIZER BAR REAR
3. REMOVE REAR SUSPENSION ARM ASSEMBLY NO.1 LH

a. Remove the bolt and disconnect the rear suspension arm assembly No.1 (inner side)

b. Remove the bolt, nut and the rear suspension arm assembly No 1 (outer side) from the rear axle carrier.

NOTICE: When removing the bolt, keep the nut from rotating.

4. TEMPORARILY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH

a. Install the rear suspension arm assembly No.1 (inner side) with the bolt, and temporarily tighten the bolt.

HINT: Ensure that the paint mark faces to the rear

b. Connect the rear suspension arm assembly No.1 (outer side) to the rear axle carrier with the bolt and nut, and temporarily tighten the bolt and nut.

NOTICE: When installing the bolt, tighten the bolt temporarily with the nut fixed.

5. STABILIZE SUSPENSION
6. FULLY TIGHTEN REAR SUSPENSION ARM ASSEMBLY NO.1 LH

a. Fully tighten the bolt.
Torque: 120 Nm (1,224 kgf-cm, 89 ft. lbs.)

b. Fully tighten the bolt.
Torque: 112 Nm (1,140 kgf-cm, 83 ft. lbs.)
7. INSTALL STABILIZER BAR REAR
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
9. INSPECT REAR WHEEL ALIGNMENT