Crankshaft Position Sensor: Service and Repair
REMOVAL1. REMOVE COOL AIR INTAKE DUCT SEAL
2. REMOVE V-BANK COVER SUB-ASSEMBLY
3. REMOVE NO. 1 INLET AIR CLEANER
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
5. REMOVE V-RIBBED BELT
6. REMOVE ENGINE UNDER COVER
7. REMOVE REAR ENGINE UNDER COVER LH
8. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE
9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
10. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY
11. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the bolt and crankshaft position sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
a. Apply a coat of engine oil to an O-ring of the crankshaft position sensor.
b. Install the crankshaft position sensor with the bolt.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
c. Connect the crankshaft position sensor connector.
2. INSTALL COMPRESSOR WITH PULLEY ASSEMBLY
3. INSTALL DISCHARGE HOSE SUB-ASSEMBLY
4. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE
5. INSTALL V-RIBBED BELT
6. INSTALL REAR ENGINE UNDER COVER LH
7. INSTALL ENGINE UNDER COVER
8. INSTALL NO. 1 INLET AIR CLEANER
9. INSTALL V-BANK COVER SUB-ASSEMBLY
10. CHARGE REFRIGERANT
11. WARM UP ENGINE
12. CHECK FOR LEAKAGE OF REFRIGERANT
13. INSTALL COOL AIR INTAKE DUCT SEAL