Speed Sensor, Front

REPLACEMENT

HINT:
^ Use the same procedures for the LH side and RH side.
^ The procedures listed are for the LH side.

1. REMOVE FRONT WHEEL
2. REMOVE FRONT FENDER LINER LH





3. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the sensor connector.





b. Remove the resin clip and 2 clamp bolts holding the sensor harness.
c. Remove the bolt and sensor.

NOTICE: Keep the sensor tip free from foreign matter.





4. INSTALL SPEED SENSOR FRONT LH
a. Install the sensor with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
b. Install the sensor harness with the 2 clamp bolts and resin clip.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)





c. Connect the sensor connector.
5. INSTALL FRONT FENDER LINER LH
6. INSTALL FRONT WHEEL
a. Install the wheel with the 5 nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Install the ornament with the 10 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft. lbs.)
7. CHECK ABS SPEED SENSOR SIGNAL