Oil Pan, Engine

Oil Pan





Temporarily install the oil pan with the 17 bolts, stud bolt and 2 nuts.

HINT: Each bolt length is as shown in the table.





Bolt length

Set the oil pan as shown in the illustration.

NOTICE: Make sure the clearance between the rear end of the oil pan and cylinder block is 0.2 mm (0.008 inch) or less. If the clearance is more than 0.2 mm (0.008 inch), the oil pan will deform when tightening the bolts and nuts.

Uniformly tighten the bolts and nuts in several passes.
Torque:
7.5 Nm (76 kgf-cm, 66 inch lbs.) for bolt A and nut
28 Nm (286 kgf-cm, 21 ft. lbs.) for bolt B