Headlamp Alignment Sensor: Service and Repair

Height Control Sensor:

HEIGHT CONTROL SENSOR

REMOVAL

1. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR RH




a. Disconnect the connector.
b. Remove the 3 nuts and the height control sensor sub-assembly rear RH.

INSTALLATION

1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR RH




a. Install the height control sensor sub-assembly rear RH with the 3 nuts.

Torque:
Rear suspension member side 8.0 N.m (82 kgf.cm, 71 in.lbf)
Lower arm side 5.4 N.m (55 kgf.cm, 48 in.lbf)

b. Connect the connector.

2. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION.
3. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT
4. PREPARATION FOR HEADLIGHT AIMING (Using a headlight aim test machine)
5. PREPARATION FOR HEADLIGHT AIMING (Using a Screen)
6. HEADLIGHT AIMING INSPECTION
7. HEADLIGHT AIMING ADJUSTMENT