Accessory Control Display: Service and Repair

Multi-Display:

MULTI-DISPLAY

REMOVAL

1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
4. REMOVE CONSOLE UPPER PANEL ASSEMBLY
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
7. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY
8. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING
9. REMOVE NO. 2 RADIO BRACKET
10. REMOVE NO. 1 RADIO BRACKET
11. REMOVE RADIO RECEIVER ASSEMBLY
12. REMOVE MULTI-DISPLAY

INSTALLATION

HINT: A bolt without a torque specification is given in the standard bolt chart.

1. INSTALL NO. 2 RADIO BRACKET
2. INSTALL NO. 1 RADIO BRACKET
3. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY
4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
6. INSTALL CONSOLE UPPER PANEL ASSEMBLY
7. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION
a. Perform initialization. Testing and Inspection

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.