Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2008 >> IS 250 AWD V6-2.5L (4GR-FSE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Front Airbag Sensor >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation








SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR:

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.





(c) Connect the connector.
(d) Install the front airbag sensor with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(e) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL HEADLIGHT ASSEMBLY Installation

3. INSTALL FRONT BUMPER ASSEMBLY
4. INSTALL FRONT UPPER FENDER PROTECTOR LH Installation

5. INSTALL ENGINE ROOM SIDE COVER LH
6. INSTALL COOL AIR INTAKE DUCT SEAL Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.
9. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT Adjustments

10. PREPARATION FOR HEADLIGHT AIMING (Using a tester) Adjustments

11. PREPARATION FOR HEADLIGHT AIMING (Using a screen) Adjustments

12. HEADLIGHT AIMING INSPECTION Adjustments

13. HEADLIGHT AIMING ADJUSTMENT Adjustments

14. VEHICLE PREPARATION FOR FOG LIGHT AIM Adjustments

15. PREPARATION FOR FOG LIGHT AIMING Adjustments

16. FOG LIGHT AIMING INSPECTION Adjustments

17. FOG LIGHT ADJUSTMENT Adjustments

18. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.
pro multis · About Operation CHARM