Installation

SLIDING ROOF: SLIDING ROOF HOUSING (for Standard): INSTALLATION

INSTALLATION

1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY






(a) Sliding the drive cable forward, install it.
HINT: Tape the screwdriver tip before use.

2. INSTALL ROOF DRIP CHANNEL REAR






(a) Install the roof drip channel rear as shown in the illustration.
3. INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY






(a) Install the housing with the 8 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Install the 4 brackets with the 8 bolts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(c) Connect the 4 hoses and drive gear connector.
4. ADJUST FULLY CLOSED POSITION






(a) Using a screwdriver, slide the drive cable of the sliding roof to align the matchmarks.
HINT: Tape the screwdriver tip before use.

5. ADJUST SLIDING ROOF GLASS SUB-ASSEMBLY






(a) Check for a difference in levels between the sliding roof (roof glass) and roof panel.
Difference:





NOTE: The clearance should be even all around.

6. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY
(a) Using a T25 "TORX" driver, loosen a screw to adjust the sliding roof panel position. When the adjustment has been done, tighten the screw there.
7. INSPECT FOR WATER LEAK
(a) Adjusting the sliding roof, inspect that there is no water leak.
If a leak is found, readjust the sliding roof.
8. RESET SLIDING ROOF POSITION Programming and Relearning

9. INSTALL ROOF HEADLINING ASSEMBLY Installation