Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION

INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY






(a) Install the tire pressure warning receiver assembly with the bolt.
Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
(b) Connect the connector.
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT: Refer to the instructions for installation of the roof headlining assembly Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

4. INSPECT TIRE PRESSURE WARNING SYSTEM Test Mode Procedure