Removal

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: REMOVAL

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE
Removal
2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. DRAIN ENGINE COOLANT Testing and Inspection

4. REMOVE WINDSHIELD WIPER LINK ASSEMBLY

5. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY Removal

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

8. REMOVE INTAKE AIR SURGE TANK ASSEMBLY






(a) Disconnect the 2 water by-pass hoses from the throttle body.
(b) Disconnect the vapor feed hose.
(c) Disconnect the throttle body connector and clamp.






(d) Disconnect the ventilation hose No. 2.
(e) Disconnect the union to check valve hose.






(f) Disconnect the connector.






(g) Using a 5 mm socket hexagon wrench, remove the 4 bolts.
(h) Remove the 2 nuts, 2 bolts and intake air surge tank.
(i) Remove the gasket from the intake air surge tank.
9. REMOVE FUEL TUBE SUB-ASSEMBLY Removal

10. REMOVE INTAKE MANIFOLD Removal

11. REMOVE KNOCK CONTROL SENSOR






(a) Disconnect the 2 knock sensor connectors.
(b) Remove the 2 bolts and then remove the 2 knock sensors.