Installation

2GR-FSE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
(a) Install a new gasket to the sensor.





(b) Install the sensor.
Torque: 20 Nm (204 kgf-cm, 15ft-lbf)
(c) Connect the sensor connector.
2. INSTALL INTAKE MANIFOLD Installation
3. INSTALL INTAKE AIR SURGE TANK Installation
4. INSTALL THROTTLE BODY Installation
5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation
6. CONNECT NO. 2 VENTILATION HOSE Installation
7. ADD ENGINE COOLANT Service and Repair
8. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation
9. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation
10. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation
11. INSTALL FRONT FENDER TO COWL SIDE SEAL LH Installation
12. INSTALL FRONT FENDER TO COWL SIDE SEAL RH Installation
13. INSTALL FRONT UPPER FENDER PROTECTOR LH Installation
14. INSTALL FRONT UPPER FENDER PROTECTOR RH Installation
15. INSTALL SERVICE PLUG GRIP Installation
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
17. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection
18. CHECK FOR FUEL LEAKS Testing and Inspection
19. CHECK FUNCTION OF THROTTLE BODY On-Vehicle Inspection
20. INSTALL V-BANK COVER Installation
21. INSTALL ENGINE ROOM SIDE COVER LH Installation
22. INSTALL ENGINE ROOM SIDE COVER RH Installation
23. INSTALL COOL AIR INTAKE DUCT SEAL Installation
24. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.