Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2009 >> LS 460 AWD V8-4.6L (1UR-FSE) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Oxygen Sensor >> Service and Repair >> Heated Oxygen Sensor >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation








1UR-FSE ENGINE CONTROL SYSTEM: HEATED OXYGEN SENSOR (for AWD): INSTALLATION

INSTALLATION





1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
(a) Using SST, install the heated oxygen sensor to the front exhaust pipe.
SST: 09224-00010
without SST - Torque: 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque: 40 Nm (408 kgf-cm, 30 ft-lbf)
HINT:
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
- Make sure SST and the wrench are connected in a straight line.

(b) Connect the heated oxygen sensor connector.
2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
(a) Exterior Side:




(1) Using SST, install the heated oxygen sensor to the front exhaust pipe.
SST: 09224-00010
without SST - Torque: 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque: 40 Nm (408 kgf-cm, 30 ft-lbf)
- Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
- Make sure SST and the wrench are connected in a straight line.
(2) Install the grommet to the vehicle.





(b) Interior Side:
Connect the heated oxygen sensor connector.
3. INSTALL REAR NO. 2 AIR DUCT
4. INSTALL FRONT FLOOR SILENCER PAD RH
5. INSTALL COWL SIDE TRIM BOARD RH Installation
6. INSTALL FRONT DOOR SCUFF PLATE RH Installation
pro multis · About Operation CHARM