Installation

1UR-FSE STARTING: STARTER (for AWD): INSTALLATION

INSTALLATION

1. INSTALL STARTER ASSEMBLY





(a) Install the flywheel housing side cover.





(b) Connect the starter connector.
(c) Connect the starter wire with the 2 nuts.
for nut A - Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
for nut B - Torque: 9.8 Nm (100 kgf-cm, 88 in-lbf)
(d) Close the terminal cap.





(e) Install the starter with the 2 bolts.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)




NOTE:
Make sure the flywheel housing cover is as shown in the illustration.

2. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR





(a) Install the heat insulator with the 3 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL FRONT NO. 2 ENGINE MOUNTING BRACKET RH Installation
4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(a) Install the exhaust manifold RH Installation.